AiroMatic Smart Roof Ventilator
AiroMatic is a powerful, Smart Roof Mounted Ventilator that continuously and reliably improves the comfort and health of your home all year round.
AiroMatic is a roof mounted, smart ventilator with clear acrylic dome, for the reduction of roof space heat & management of moisture and damaging condensation.
The high quality polymer based ventilator with a clear, high impact acrylic dome provides four speed settings (automatic, low, medium and high) to manage excess heat and moisture in the roof space, providing a more comfortable and healthier home. In addition, the management of moisture helps to reduce the chances of condensation damaging roof rafters, insulation and ceilings.
One AiroMatic is equivalent to six wind driven vents and can be used on a continuous basis, without reliance on the wind.
The quiet motor and low cost to run make this ventilator a valuable addition to the comfort level in your home. In addition, the Edmonds partnership with the Asthma and Respiratory Foundation NZ shows the support for AiroMatic as a provider of better quality air, especially for those suffering from asthma and allergies.
-
Installation guidelines
Installation Guidelines
Installation for tiled roofs
Remove one tile three rows down from ridge cap. Cut and fold back sarking if required.
Slide the flashing under the tiles above the opening and fold the bottom edge to seal
against lower tiles. Apply a bead of silicone under the side and front edges of the flashing
for a weatherproof installation.
From within the roof space, fit the fixing strap by hooking it between the flashing up stand and the outer housing.
Screw or nail the fixing strap to the bottom batten.Installation for metal roofs
Position vent appropriately and slip the top edge of the flashing under the ridge capping. Mark the position of the vent. Back flashing must be used if positioned lower down the roof.
Using the marks, cut a 250mm square opening.
Slip the top of the flashing under the ridge cap and dress the flashing into the metal sheet corrugations. Run a bead of silicone underneath the three exposed sides.
Secure the flashing to the metal sheeting with TEK screws or sealed rivets along the 3 exposed edges of the flashing.
